Fermod Floor Guided Sliding Door Hardware Kits -
F2156 Installation Guide
www.crh.com.au
18
Step 13.
Install the door brackets on the main rail and running
profile. Install each door bracket from the centre ramp
and slide to the left & right.
Step 14.
Attach the door brackets to the door blade.
1. Wedge Up the door blade & bolt/screw the door
brackets into the previously pre-drilled & tapped
holes.
Step 15 - Adjust the door.
1. With the door in the closed position, the floor and
frame gaskets should create a firm seal, however the
gaskets should not be squashed and out of shape. If
the seal at the top of the door is too tight it will push
the bottom out and guides will not run smoothly.
2. When the door is running, the gaskets should not
touch the frame or floor.
3. Height adjustment can be achieved by adjusting
the door brackets as shown.
4. Tightness against the frame can be adjusted by
adjusting the floor guide. See Fig A & B on the next
page.
5. Loosen A for horizontal adjustment then tighten.
±11
B
C
A
A19 A20
A22 A21
A23
A25 A24
D= Right Hand Side
G= Left Hand Side
G
D
TO ADJUST DOOR:
Loosen screws C 1/2 turn.
Tighten or loosen screw B
Lock screw C
Wedge 20mm
