CRESTRON
14
••
SmartPresenter™: SP-1
Operations Guide - DOC. 5712
NOTE:
Crestron recommends that the “linked” device be either a video projector
or switcher.
For example, if a VCR (assigned to button 1) is required to select the Video1 input
on a projector (assigned to button 4), it is necessary to link device 1 to device 4 to
make the macro function automatically.
1.
Assign a valid Q-Code to output device 4.
2.
Verify by selecting device 4 and pressing the device control buttons,
until the correct image is displayed. Make a notation for each device
needed to link. The information is required to successfully complete
this procedure.
Device Control Buttons (A Through F) on Transmitter
3.
Depress (with a blunt object e.g., paper clip) the recessed device
assignment button 4 on the SP-1.
Observe flashing red device output #4 LED.
4.
Depress the SP-1 recessed device assignment button (numbered 1, 2,
or 3) associated with a device to be “linked”.
Observe two flashing red device output LEDs (4 and the LED for the
device to be “linked”).
5.
Per the information gathered in step 2, select a function for the device
assigned to output 4 by depressing a device control button on the
transmitter.
Observe that the two flashing device output LEDs extinguish and the
red RF LED illuminates for approximately five seconds.
6.
Repeat steps 3 through 5 for the other two device outputs on the SP-1,
if applicable.
