CRESTRON
10
••
SmartPresenter™: SP-1
Operations Guide - DOC. 5712
Match Transmitter ID to SP-1
Communication between the SP-1 and the transmitter is established via the RF ID
of the transmitter. This ID can be transmitted to the SP-1 to ensure that the SP-1
recognizes a given mouse. Notice the location of the position A button on the
transmitter and complete the following procedure.
Location of Position A Button on Transmitter
1.
Test if the RF ID matches by depressing (position A) button on the
transmitter.
If the RF LED illuminates and remains on for about four seconds,
communication is verified and no further steps need to be taken.
If the RF LED does not illuminate, proceed with the next step.
2.
Depress (with a blunt object e.g., paper clip) and
hold
recessed button
#1 on the SP-1 for at least five seconds or until the RF LED flashes.
3.
Depress (position A) button on the transmitter while the RF LED
flashes.
Observe that the RF LED stops flashing and remains illuminated for
about four seconds. An extinguished LED indicates a match of
transmitter ID to that of the SP-1
If two or more SmartPresenter systems are operating in close proximity of one
another, it may be necessary to change the transmitter RF ID. There is a simple
procedure to change the RF ID using device button presses on the transmitter.
Complete the following procedure to set an RF ID.
1.
Open battery compartment and remove one battery.
2.
Depress and hold button 1 on the unit while replacing battery.
3.
Replace battery compartment cover and release button 1.
4.
Use the device buttons on the transmitter to enter one of the eight-digit
codes found in the table after this step.
Location of Device Button 1 on Transmitter
