CRESTRON
Operations Guide - DOC. 5712
SmartPresenter™: SP-1
••
9
hardware setup is required. Due to the multiple applications, an overall hookup
diagram is presented after this paragraph. Not every connection is required.
Complete the following hardware hookup procedure in the order presented.
Possible Hookup Connections for the SP-1
1.
Attach antenna to SP-1 using right angle adapter.
2.
Disconnect power to the PC (only if PC mouse/keyboard is used).
3.
Attach all necessary PC cables to PC and SP-1 (only if PC
mouse/keyboard is used).
4.
Connect power (model PW-1205, PWI-1210, or equivalent) to SP-1
input power jack (labeled as 12VDC .5A).
5.
Plug power pack into active outlet.
One or more of the feedback options occur, then observe that the
green PWR LED turns on.
•
All LEDs (1 through 4) flashing simultaneously, three times,
indicates there is an invalid setting for one of the devices. Refer to
“Q-Code Assignment Error” on page 12 for details.
•
LEDs 1 and 2 flash to indicate that that a valid mouse driver is
installed and a mouse is properly connected to the MOUSE IN
port.
•
LEDs 3 and 4 flash to indicate that that a valid keyboard driver is
installed and a keyboard is properly connected to the
KEYBOARD IN port.
•
LEDs illuminate in a reverse sequence (4-3-2-1) to indicate SP-1
is ready to use.
6.
Apply power to the PC (only if PC mouse/keyboard is used).
