Crestron
MPS-300
Multimedia Presentation System 300
Control from a Keypad
The following describes operation of the system when using the out-of-the-box
functionality and either a C2N-DB12 or CNX-B12 keypad. If a custom program has
been created, the MPS-300 may function differently.
NOTE:
Buttons for the keypad are custom engraved using Crestron SystemBuilder
software. For instructions on installing the buttons on the keypad, refer to the
keypad’s guide.
The keypad has twelve buttons as shown in the following diagram.
C2N-DB12 Buttons
BNC 1
BNC 2
RGBHV 4
QM IN 6
QM IN 7
QM IN 8
POWER
RGBHV 3
RGBHV 5
MUTE
VOL UP
VOL DOWN
NOTE:
Custom buttons can be created using Crestron Engraver software. For
instructions on installing the custom buttons, refer to the keypad guide.
When switching sources from the keypad, the MPS-300 will route the signal to the
projector output and then route the signal to the touchpanel output.
Turn On the System
To turn on the system, press any of the source buttons on the left-side of the button
pad. The selected source will be routed to all of the outputs.
NOTE:
Typically, signal routing information is not displayed on the front panel of
the MPS-300. However, if an output button on the MPS-300 was pressed at any
point during operation, routing information will be displayed and updated should any
changes to routing be made.
Turn Off the System
To turn off the system, press the
POWER
button.
Adjust the Volume Level
To raise the volume level, press the
VOL UP
button. To lower the volume, press the
VOL DOWN
button. The volume buttons will only control the volume parameter
that was selected when the Volume Control Mode was specified as described on
page 46.
Mute Audio
To mute the audio output, press the
MUTE
button. To unmute, press the
MUTE
button again. The front panel of the MPS-300 will indicate the status of the mute
function.
Operations Guide – DOC. 6529B
Multimedia Presentation System 300: MPS-300
•
81
