Crestron
TPS-4500V & TPS-4500LV
12 Inch Tilt/Lectern Touchpanels
Securing Two Plates to Top and Bottom Edges of Opening
TWO PAN
HEAD
SCREWS
(MOUNTS PLATES
IN TWO CENTER
TAPPED HOLES)
DRYWALL
LARGE
METAL
MOUNTING
PLATE
SMALL
METAL
MOUNTING
PLATE
10. Repeat steps 7 through 9 for the bottom horizontal edge of the opening.
11. Attach the network cable and other cables (i.e., RS-232 or video) in the
wall to the appropriate connector on the back of the touchpanel. Refer
to “Network Wiring” on page 9 for network wiring details. Information
about the RS-232 connector is located in “RS-232” on page 15. For
wiring the video connector, refer to “Video” on page 16.
12. Position the touchpanel (less the faceplate) into the opening and secure
with eight pan head screws, supplied. Tighten by hand; do not fully
tighten screws.
Positioning Touchpanel into Opening
DRYWALL
NOTE:
WIRING NOT SHOWN
FOR CLARITY
POSITION
AND SECURE
TOUCHPANEL
INTO OPENING
13. Use the #2 Phillips screwdriver and fully tighten all 12 pan head
screws. Use caution and do not crack or damage mounting surface.
14. Mate the four posts of the bezel with the holes drilled into the mounting
surface and firmly press on the bezel over the touchpanel.
Operations Guide - DOC. 6160
12 Inch Tilt/Lectern Touchpanels with Video: TPS-4500V & TPS-4500LV
•
21
Summary of Contents for Isys TPS-4500LV
Page 4: ......