Crestron Isys
®
TPS-4000
10.4 Inch Tilt Touchpanel
File Transfer | Send Touchpanel Command
3. As shown after this step, select the Net ID of the TPS-4000 touchpanel and
then click
OK
. The “Touch Panel Transfer” window appears (refer to the
subsequent graphic).
“Select Network ID” Window
Check
Send Direct to Wired Touchpanel
if
connected via RS-232 directly to touchpanel.
NOTE:
If problems occur when transferring any Cresnet file (touchpanel
project/firmware), lower the port speed baud rate to 38400 to match the Cresnet bus
speed when transferring through a control system.
“Touch Panel Transfer” Window
Each time a project is selected using
the
Browse
command, that project is
added to the
File Name
drop-down
list. This makes it convenient to
recall projects without need to
browse to a directory. To delete the
list click
Clear History
.
All Files in Project
: sends the entire
project.
Only Changed Files
: sends only the
files that are different from those that
are currently stored in the panel.
Note that if any pages in the panel
are not present in the project, those
pages will be deleted from the panel.
Additional choices include
Do not send graphic files
and
Do not send sound files
.
These are often very large files that take a long time to load.
4. Click
Browse
. The “Open” window appears as shown in the following
illustration.
Operations Guide - DOC. 6268
10.4 Inch Tilt Touchpanel: Crestron Isys
®
TPS-4000
•
33
