Supplemental Guide – DOC. 7797D
DM Lite HD(I)-MD Auto-Switchers and Extenders
•
19
7.
(Applicable only when Send command is set to CEC, RS232, or IR) Do one of the
following:
•
Click Save to save the power-off settings.
•
Click Test to test the command. If the command is successful, click Save to
save the power-off settings.
Configure Power-On Settings
If Automatic Power Settings is set to Enable, configure power-on settings by doing the
following in the Power On (Sync Detected) section:
1.
Select one of the Send command radio buttons to choose the interface to send a
power-on command: None (default setting), CEC, RS232, or IR.
•
If None is selected, no command is sent. Click Save to save the power-on
setting.
•
If CEC (Consumer Electronics Control) is selected, continue with step 2.
•
If RS232 is selected, skip step 2 and proceed to step 3.
•
If IR is selected, skip steps 2 and 3 and proceed to step 4.
2.
(Applicable only when Send command is set to CEC) In the CEC drop-down list,
select one of the following to turn on the output:
•
Power On: RCP (Remote Control Passthrough) and IVO (Image View On)
•
Power On: RCP
•
Power On: Image View on
•
Custom
If RCP and IVO, RCP, or Image View on is selected, skip steps 3 and 4 and
proceed to step 5. If Custom is selected, continue with step 3.
3.
(Applicable only when Send command is set to CEC Custom or to RS232) Do the
following:
a.
Select the Hex or Ascii radio button to specify the format of the command.
The default setting is Hex.
b.
In the Command text box, enter the command in hexadecimal or ASCII
format.
c.
In the Terminator drop-down list, select one of the following terminators to
append to the command: None (specifies no terminator), CR (carriage
return), LF (line feed), or CR LF (carriage return followed by a line feed). The
default setting is CR LF.
d.
Skip step 4 and proceed to step 5.
