DigitalMedia™ CAT Receiver
Crestron
DM-RX1-1G
NOTE:
Braid should wind neatly around foil shield. Loose braid
may cause shorts.
“D” Cable (Wrapping the Twisted Braid)
Braid Wrapped
Around Foil Shield
7.
Strip the insulation from the ends of each wire, exposing
approximately 3/16 inch (5 mm) of bare copper.
NOTE:
Do not allow the twisted pairs to untwist for more than 1/2
inch (13 mm).
NOTE:
Maintain equal wire lengths within 1/8 inch (3 mm).
8.
Using an adjustable wrench, clamp the prepared cable to the unit
as shown in the following illustration.
NOTE:
Twisted braid and foil shield must be in full contact with
inside of clamp.
16
•
DM
®
CAT Receiver: DM-RX1-1G
Operations & Installation Guide – DOC. 6969B
