DigitalMedia™ CAT Receiver
Crestron
DM-RX1-1G
Rack
Mounting
The DM-RX1-1G can be mounted in a rack with other equipment using
the two mounting holes on either corner of the unit. It is assumed the
required cable has been installed and wiring has been verified.
WARNING:
To prevent bodily injury when mounting or servicing this
unit in a rack, take special precautions to ensure that the system remains
stable. The following guidelines are provided to ensure your safety:
•
When mounting this unit in a partially filled rack, load the rack
from the bottom to the top with the heaviest component at the
bottom of the rack.
•
If the rack is provided with stabilizing devices, install the
stabilizers before mounting or servicing the unit in the rack.
1.
Follow steps 1 through 12 in “Installing in a 1-Gang Box”, which
starts on page 14.
2.
Attach the unit to the rack using two rack mount screws (not
supplied) as shown in the following illustration.
3.
Remove the pre-cut insulation from the grounding wire and
connect it to an appropriate earth ground.
4.
Remove the backing from the tape on the back of the included
insert. Affix the insert plate onto the unit as shown. Refer to the
following illustration.
20
•
DM
®
CAT Receiver: DM-RX1-1G
Operations & Installation Guide – DOC. 6969B
