Web Interface Configuration Guide — Doc. 8874D
DM-NVX-D30/E30(C) • 19
l
Auto Initiation: Move the Auto Initiation slider to the desired position (enabled or disabled)
to specify whether the stream will automatically start when the correct parameters are
set. By default, Automatic Initiation is enabled.
Press the Start or Stop button to start or stop a stream if Automatic Initiation is disabled.
Note that when Automatic Initiation is disabled, the device will not attempt to start a
stream until the Start button is pressed.
l
Custom Ports: Toggle the Custom Ports switch to enable the option to specify a custom
RTSP or TS port. Crestron recommends using a custom port value greater than 10000.
l
RTSP Port: Enter a custom TCP port number for the RTSP server of the primary
audio/video stream (Transmitter mode only).
Valid values range from 1 to 65535. By default, the RTSP Port of the DM-NVX-D30/E30(C)
is set to port 554.
l
TS Port: Enter a custom UDP port at which both audio and video are transmitted. The
value must be an even number. An odd value will be rejected by the device. By default, the
TS Port is set to 4570. Valid values range from 1 to 65530.
l
Adaptive Bitrate: (Only applicable in Transmitter Mode) Select this option to have the
device adapt the bitrate automatically based on the resolution of the stream. If this is
selected, the bitrate cannot be manually selected with the Bitrate option below.
l
Bitrate: (Only applicable in Transmitter Mode). Select a bitrate from the Bitrate drop-
down list to set the bitrate of the transmitted stream in Mbps. Crestron recommends
using the default value.
l
Select Custom in the Bitrate drop-down list and type a custom value (in Mbps) in the
Custom Bitrate field below.
l
Active Bitrate: Displays the current bitrate of the stream.
l
(Only applicable in Transmitter Mode) Toggle the Custom TTL switch to enable the option
to enter a custom TTL (Time-to-Live) value in the TTL field. TTL values can range from 1 to
255.
l
(Only applicable in Transmitter Mode) Toggle the Custom DSCP switch to enable the
option to enter a custom value in the DSCP field. DSCP values can range from 1 to 63.
l
Statistics: Toggle Statistics to enabled in order to view Packets Transmitted and Packets
Dropped. Click Reset Statistics to reset this information.
l
Audio/Video: Displays information for Audio Channels, Audio Format, and Audio Ratio.
