Test the Shade
Before the shade is operated, test the motor to ensure that the shade
travels in the correct direction when being operated.
NOTE:
Before using the CSM(I)-QMTDC shade motor, ensure the device
is using the latest firmware. Check for the latest firmware for the CSM
(I)-QMTDC shade motor at
. Firmware is
loaded onto the device using Crestron Toolbox™ software.
Test the Motor Direction
Press the DN button to lower the shade about 1 inch. If the shade travels
up, reverse the motor direction.
NOTE:
Reversing the motor direction resets all previously set limits.
After either the upper or lower limit is set, the motor automatically
enters Limit Setup mode for the opposite limit. Follow the procedure in
to reassign limits.
To reverse the shade direction, press and hold the SET button for
10 seconds. The red LED lights for 3 seconds.
Test the Shade Travel
Test the travel of the shade fabric to ensure that it does not come in
contact with building materials and that the upper and lower shade limits
are properly set.
WARNING:
Care has been taken to ensure that the shade is properly
balanced. Prior to initial operation, confirm that the brackets are
adjusted so that the shade hangs level and plumb. Upon startup, run the
shade all the way down and check for plumb. Observe the shade closely
as it rolls up. If the shade begins to telescope, stop immediately and take
the appropriate action to ensure the shade tracks properly. To prevent
damage to the fabric from telescoping, do not leave the shade
unattended during the first few cycles of operation. Failure to follow
these instructions may result in damage to the edge of the fabric, which
is not covered by the warranty.
NOTE:
For Crestron Horizontal Sheers, the lower limit is defined as the
point before the hem bar tilts.
To test the lower limit:
1. Using the DN button, lower the shade until it reaches its lower limit.
Stop and adjust the mounting brackets if the fabric contacts any
building materials.
2. Verify that the shade stops at the desired lower limit. If the shade does
not travel to the desired lower limit, adjust the shade limits. For details,
refer to
.
To test the upper limit:
1. Using the UP button, raise the shade until it reaches its upper limit.
Stop and adjust the mounting brackets if the fabric contacts any
building materials.
2. Verify that the shade stops at the desired upper limit. If the shade does
not travel to the desired upper limit, adjust the shade limits. For
details, refer to
.
9
CSA-DECOR3 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
