Adjust the Roller Shade Assembly
Once the roller shade assembly is mounted, make adjustments to level the
shade and center it in the opening.
WARNINGS:
l
Care has been taken to make sure that the shade is properly
balanced. Prior to initial operation, please confirm that the brackets
have been adjusted so that the shade hangs level and plumb. Upon
startup, run the shade all the way down and check for plumb.
Observe the shade closely as it rolls up. If the shade begins to
telescope, stop immediately and take the appropriate action to make
sure that the shade tracks properly. To prevent damage to the fabric
from telescoping, do not leave the shade unattended during the first
few cycles of operation. Failure to follow these instructions may
result in damage to the edge of the fabric, which is not covered by the
warranty.
l
If the roll-up diameter is close to the maximum allowance, do not use
the vertical adjustment screw to level the shade. The fabric may
come in contact with the bracket, fascia, or other hardware, which
may cause damage to the fabric. Remount the bracket to level the
shade.
Situations that may cause telescoping:
l
The shade is not perfectly level.
l
The shade may bump into objects while traveling up or down.
l
The HVAC ductwork is blowing on the shade, or air is coming in
through a window.
l
A foreign object is stuck to the shade fabric (for example tape, bugs,
dust, etc.).
Ways to prevent telescoping:
l
Use the leveling features built into the shade brackets to make sure the
shade is level. If the bracket adjustment is not enough to compensate,
use a shim to level the system.
l
Make sure that no obstructions exist near the window area that the
shade could bump into while traveling (for example, latches and
cranks).
l
Direct HVAC airflow away from the shade, and make sure that
windows are closed while operating the shade.
l
Lower the shade all the way down to the bare tube (the shade will need
to be placed into Limit Setup mode to allow the shade to travel below
its lower limit). Inspect the front and back of the shade to make sure
that no foreign objects are stuck to the shade fabric.
Adjust the Roller Shade Assembly
If the shade is still telescoping, it can be re-shimmed by applying a small
(1 in. x 1 in.) piece of tape to the end of the tube that the fabric should
move toward. Make sure that the tape is placed on the bare tube for best
results. The shade must be rolled all the way down past its lower limit. To
do this, place the shade motor into Limit Setup mode.
l
If the fabric is telescoping to the left, place the tape on the right side of
the tube.
l
If the fabric is telescoping to the right, place the tape on the left side of
the tube.
4
CSA-DECOR3 Series
Quick Start
Shade Motor Bracket Installation and Motor Programming
