Crestron
AV2 & PRO2
2-Series Integrated Dual Bus Control System
The job may be copied to any folder or directory, and the User IR, Module, and
SIMPL+ files will be copied to the proper directories. Extract the files into the same
directory where the archive was copied. Once files are extracted, retain the original
ZIP file in case the files need to be restored at any point. The User IR, Module, and
SIMPL+ modules will need to be copied to their proper directories manually.
Obtaining Communications
NOTE:
If an optional Z-BUS expansion card is installed into the 2-Series integrated
dual bus control system, communications can be obtained over TCP/IP. The
Operations & Installation Guide for the card explains how to load the required IP
Table that contains the addresses of the Ethernet devices and set up the control
system for Ethernet communications. Refer to the C2ENET-1 & C2ENET-2
Operations & Installation Guide (latest revision of Doc. 5962) for further
information.
Before attempting to upload the program files into the 2-Series integrated dual bus
control system, it is necessary to first establish communication between the unit and
a PC. There are two ways of communicating with the control system, either via the
COMPUTER port (RS-232 serial communications) or via Ethernet if the optional
Z-BUS expansion card is installed. Prior to completing the following steps, be sure
the communication cable is properly connected as described in "Loading Crestron
Control Software" on page 21.
NOTE:
Type of cable depends if communication is via RS-232 or Ethernet.
If RS-232, use a standard/straight through cable.
If Ethernet via hub, use straight RJ45 8-pin.
If Ethernet via PC direct, use X-over RJ45 8-pin.
1. Make sure that no programs accessing the COM port of the PC are
running.
2. Select
Start | Programs | Crestron
| SIMPL Windows
to start SIMPL
Windows.
3. SIMPL Windows responds with an opening splash screen and may
display the “What do you want to do?” window. If so, close the
window.
4. As illustrated after this step, select
Tools | Viewport
to open the
Crestron Viewport.
Accessing the Crestron Viewport
Operations Guide - DOC. 5957
Integrated Dual Bus Control System: PRO2 & AV2
•
25
Summary of Contents for 2 Series
Page 1: ......
