2
CAUTIONS:
IF ANY OF THE BRACKETS, RAILS, CABINET STRAPS, PIVOT BAR OR GROUND STACK BRACK-
ETS HAS BEEN DAMAGED OR DISTORTED, DO NOT USE, AND DO NOT STACK THE ARRAY UNTIL
THEY CAN BE REPLACED OR REPAIRED!
DO NOT USE THE PIVOT BAR OR ANGLE SLIDER BRACKET AS HANDLES TO TRANSPORT THE
CABINETS!
DO NOT TRANSPORT THE CABINETS IN ARRAY CONFIGURATION COUPLED TOGETHER, OR
WHILE STACKED ON TOP OF THE SUB.
TRANSPORT WITH THE RECOMMENDED TRANSPORT CART AND IN THE STIPULATED MANNER
FOR THAT CART IS THE ONLY APPROVED METHOD FOR TRANSPORTING THE CABINETS IN THE
ARRAY CONFIGURATION. TRANSPORT IN AN UNAPPROVED MANNER VOIDS THE WARRANTY,
AND THE SYSTEM WOULD BE CONSIDERED UNSAFE TO BE FLOWN AFTER SUCH AN UNAP-
PROVED TRANSPORT EVENT.
Correct use and seating of the Quick Release Push Lock Pins Used with most all Versarray™ rigging hardware
When using the Quick Release Positive Lock Pins, when the Quick Release Push Lock Pins are inserted, they
should be fully seated, so that the black shoulder near the end of the pin has been placed flush with the side of
the bracket, or as far in as the pin hole cavity will allow it to be inserted.
You will have to fully depress the center push-button to do this.
You should not be able to pull these pins out unless the center push-button is fully depressed.
The Crest Audio® Versarray™ loudspeaker models should be stacked on top of the Sub only in accordance
with the procedures and limitations specified in the User’s Manual and possible manual update notices.
Do not at- tempt to suspend/stack unless you have read and properly understood all instructions. This system
should be connected with certified rigging hardware by an authorized rigging professional and in compliance
with local, provincial or national suspension ordinances. ALWAYS USE PROPER GRADE
HARDWARE.
Design and specifications subject to change without notice.
