5
Rear Pivot Bar Bracket
1.
After the four bolts have been removed, place the bracket into position. Orient it so that the angle
part of the bracket is pointing toward the rear of the cabinet. See Fig. 9
Figure 9
2.
Place the bolts through the mounting holes in the bracket into the holes in the cabinet. See Fig 10
Figure 10
3.
Slowly tighten down the bolts, while moving the wrench from bolt to bolt. This allows the bolts to
tighten the bracket down evenly. This, also, allows the head of the bolts to grab in the mounting holes and
allow for self centering. You might have to slightly maneuver the bracket to assist with this.
Note: If this bracket does not square up and align properly, the Angle Slider Bracket on the back of the
cabinet being set in place will not line up correctly. This will make it hard to pin the cabinet to the bracket.
