11
3.
Remove the Pivot Bar hole pin from the Angle Slider Bracket on the second cabinet. Swing the Pivot
Bar up and out of the way. See Fig. 24 and 24a
Figure 24
Figure 24a
4.
Predetermine what angle the second VR112 will be used in, 0 thru 15 degrees. Remove the pin from
the Lock Pin hole on the Angle Slider Bracket. Adjust the Angle Slider Bracket until the angle arrow lines
up with the desired angle point as shown by the arrow labeled Angle on the Angle Slider Rail. For details
on setting the 7.5 degree angle refer to the VR112 owners manual for instructions. Insert the pin into the
Angle Pin hole. This sets the angle of the cabinet to desired angle. See Fig. 25 and 25a
Figure 25
Figure 25a
