ONE
15
Original instructions.
Filter.
Part no:
6163022
A filtration device is provided with the accesories of the machine to be installed inside the tank.
For 1st use:
- Take the reservoir out of the machine. Fill it with cold water and immerse the filter for 2 min. Put the filter
upwards to ensure that no air is trapped inside.
- Empty the tank and fit the filter inside the reservoir bottom valve. Push down to lock into place.
- Fill the reservoir again with cold water before placing it in position inside the machine.
- Set the reminder on top of the filter for replacement. Recommended each 2 months.
Important
:
Always maintain the water filtration device or system in accordance with the manufacture’s specifications.
Failure to routinely maintain the filtration device or system will result in limescale build-up inside the machine’s hydraulic
system which will eventually result in machine failure. Please read more under the cleaning and care section.
Internal filtration device (Water tank supply)
External filtration device (Water mains supply)
1.
Ensure that a water filtration device or system is installed in-line in the domestic water supply ahead the machine to prevent
contamination inside the machine’s hydraulic system. Contact a service technician to do this task if you are not confident about
performing the steps below.
2.
Open the water tap and allow the filter to fill (if new/previously unused). Then the machine’s steam boiler will begin to fill. Check
carefully around the service area for leaks or drips. If leaks/drips are detected turn off the tap immediately and check/
tighten any leaking fittings.
Only use safe drinking water with a hardness rating between the parameters on the following table. If the hardness value is below
this limit, corrosion of hydraulic components is likely. If the value is higher, lime-scaling inside the boiler will occur. In both cases,
the proper function of the machine and quality and taste of the coffee will be negatively affected.
If drinking water is not within the ratings shown above, a water filter must be installed inline ahead of the espresso machine.
Failure to install a water filter will result in voiding of the warranty and any damage resulting from limescale buildup will be the
responsibility of the owner.
· Water filter requirements
Important
:
Reservoir with filter must be fed only with unsoftened cold potable water.
Water of unsafe or unknown microbiological quality may not be used.
Value
French Hardness
German Hardness
T.D.S.
Range
5-8 ºfH
3-5 ºdH
90-150 ppm
INSTALLATION AND START UP
1.
Connect one end of
the flexible drain tube to the drain cup outlet.
(It is located under the machine. Contact a service technician to do
this task (if you are unsure how to access this area of the machine).
2.
Connect the other end of the drain tube to the domestic plumbing drainage
system in the service area.
3.
Remove the screw of the drain hole at the bottom of the drip tray and
replace/reinstall it with the grill.
Pro Tip:
Ensure that the drainage tube is not twisted and
that it is below the level of the drain cup to prevent
trapping water and other residue in the tube which could
mold or produce bad smells. Adjust the height of the
machine with the feet if needed.
WARNING
!:
Some models are equipped with boiler
drainage. Emptying the boiler must be performed by
qualified personnel.
· Drain connection checklist
Flexible drain tube Drain cup