Creative XP GlassRaven 4G, User Manual

Page: 31 / 48

31
Troubleshooting
6.1 Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm
environmental conditions, set the Sensor Level to “High” and for cold weather
use, set the sensor to “Low”.
2. Try to set your camera up in an area where no heat resources are in the
camera’s field of view.
3. In some cases, setting the camera near water will make the camera take
images with no subject in them. Try to aim the camera overground.
4. Try to set the camera on stable and immovable objects, i.e.: large trees.
5. At night, the motion detector may detect beyond the range of the
IR illumination. Reduce the distance setting by adjusting sensor sensitivity.
6. Rising sun or sunset can trigger the sensor. The camera must bereoriented.
7. If person/animal moves quickly, it may move out of the camera’s field of
view before the photo is taken. Move camera further back or redirect camera.
6.2 Camera Stops Taking Images or Won’t Take Images
1. Please make sure that the SD card is not full. If the card is full, the camera
will stop taking images or user can turn on Cycle Recording to avoid such
problem.
2. Check batteries to make sure that alkaline or NiMH AA batteries have
enough power for the camera to work.
3. Make sure that the camera power switch is in the “On” position and not in
the “Off” or “Test” modes.
4. When the 4G function is on, there will be around 1-minute interval for the
camera to send out photo before the camera will shoot the next photo.
Without a SIM card on, the camera can shoot photos continuously.
5. Please format the SD card with camera before using or when the camera
stops taking images.