Assembly
© Copyright 2010, Creative Playthings. Printed in U.S.A.
MODEL PS10FRA
19766-100 Rev B (05-10)
Page 12
ASSEMBLY INSTRUCTIONS
STEP 10 – Side Supports:
Fasten the bottom of each Angled Side Support (C) to the
Gym Base Rail using two 1/4" x 2-1/2" Hex Bolt Assemblies.
/HDYHÀQJHUWLJKW6ZLQJWKH$QJOHG6LGH6XSSRUWVDJDLQVW
the Left Corner Posts as shown. Using a level check that the
Corner Posts are plumb. Mark the position that the upper
hole in the Side Support meets the Corner Posts. Use a 1/8"
drill to make a 2-1/2" deep pilot hole in each Corner Post.
Attach the Side Supports to the Corner Posts using 1/4 x 4"
Lag Screws and 1/4" Flat Washers.
STEP 11 – Square and Secure Gym:
Use a level and square to check that the Corner Posts are
plumb and the Side and End Supports are level. Once the
position is satisfactory, tighten the bolts holding the Angled
Side Supports to the Gym Base Rail and the Angle Braces
to the Corner Posts. Check Gym position again and then
tighten the bolts that connect the Angle Braces to the Plat-
form Ends.
)LQDOO\ ÀQLVK VHFXULQJ WKH 6DQGER[ (QGV WR WKH &RUQHU
Posts using #10 x 2" Flat Head Wood Screws in the holes
provided.
STEP 12 – Platform Boards:
3ODFHRQH3ODWIRUP%RDUG;ÁXVKWRWKHHGJHRIHDFK3ODW
-
IRUP(QGDVVKRZQ(YHQO\VSDFHWKHÀYHUHPDLQLQJ3ODW
-
IRUP%RDUGVEHWZHHQWKHÀUVWWZR3ODWIRUP%RDUGV)DVWHQ
HDFKWRWKHSODWIRUPIUDPHXVLQJÀYH[)ODW+HDG
Wood Screws.
X
1
4
C
C
3
2
Drill Pilot Hole
