Instruction Sheet
Glider Bolster 1006 Standard / 1007 Mini
Store these instructions with the enclosed maintenance checklist in
a safe place. You may also access them on our website.
Take time to familiarize yourself with the use and maintenance of this equipment before using. Please file this
Instruction Sheet in an accessible location: the Instruction Sheet must be read and familiar to anyone who is
using Southpaw Enterprises Equipment.
Warning: Failure to properly install a forged
steel eyebolt (1/2” or 5/8”) may result in serious
injury or death. If you have any questions
about the installation of the forged steel
eyebolt, please contact Southpaw Enterprises
Customer Service at 1-800-228-1698.
IMPORTANT: Please check equipment immediately for any damage
that may have resulted during shipping. If any damage has occurred,
please contact Southpaw Enterprises, Inc. immediately.
SPACE REQUIREMENTS
Minimum height must be 7 feet
Clearance from walls and other obstacles must be at least 6 ft.
HANGING PROCEDURE
Note:
Glider Bolster will hang from 2 or 4 suspension points. If 4 points are used, you will need 2 more safety
snaps. Height Adjusters (5000) and Safety Rotational Devices (2000) are recommended but not included with
Bolster. Be sure to use Southpaw Therapy Rope (150) and
Eye Splice (151) with Southpaw Height Adjuster.
Attach your Glider to your ceiling eye bolts with the
Safety Snaps provided.
Recommended suspension points for the Standard Glider
Bolster, must be between 5-1/2 ft and 6-1/2 ft. apart as this is
the most stable configuration. It
can
also be suspended from a
single suspension point. Suspension points for the Mini Glider
must be between 3-1/2 ft. and 5-1/2 ft. apart.
If you wish to suspend your Glider Bolster from 4 points you will
need 2 additional Southpaw Safety Snaps. The second set of
suspension points for the Glider Bolsters should be parallel to
the first set, and about 1-1/2 ft. to 2 ft apart from each other.
The
WORKING LOAD
is 400 lbs.
Drawing shown with two Southpaw Height
Adjustment Systems, not included
MATERIALS LIST
1006 Std. Glider Bolster
1007 Mini Glider Bolster
1 - 1006 Glider Bolster
1 - 1007 Glider Bolster
2 - Safety Snaps
2 - Safety Snaps
1 - Safety Snap Instruction Sheet
1- Safety Snap instruction Sheet
1 - Instruction Sheet
1 - Instruction Sheet
1 - Maintenance Checklist
1 - Maintenance Checklist
Soft/Firm
foam on top
Soft/Soft foam
on bottom
The Glider Bolster is designed with different density foams on each
side for the comfort of your clients. The top (blue) has one layer of
soft foam and one layer of firm foam, and the bottom (green) has two
layers of soft foam. Simply hang the bolster with the desired side fac-
ing up. The bolster is stable in both orientations.
