Assembly
MODEL PS10FRA
19766-100 Rev B (05-10)
© Copyright 2010, Creative Playthings. Printed in U.S.A.
Page 17
ASSEMBLY INSTRUCTIONS
67(3²5RFNV
Fasten the Climbing Rocks to all the holes in the Rock Boards
using two 1/4 x 1" (or 1-1/2") Hex Bolts, 1/4" Lock Washers,
8 MM Flat Washers and 1/4" Weld Nuts for each Rock. The
bolt must seat completely into the Climbing Rocks, and not
protrude more than a 1/8" past the end of the Weld Nut.
Protruding bolts can be a hazard to users, replace any pro-
truding Bolts.
This gym may come equipped with either 1/4 x 1" or 1/4 x
1-1/2" Hex Bolts for this step.
67(3²+DQG*ULSV
3DQG*ULSÁDWDJDLQVWWKHEDFNIDFHRIWKHEDFN
Left Corner Post as shown. The bottom hole of the Hand
Grip should be approximately 8" above the top of the Plat-
form surface.
With the Hand Grip centered on the face of the Corner Post,
mark the positions of the holes in the Hand Grip. Drill 1/8"
diameter pilot holes 1" deep at the marks. Fasten the Hand
Grip using two 1/4" x 1-1/2" Lag Screws and two 1/4" Flat
Washers.
Repeat, mounting a Grip in each of the positions shown.
P
STEP 27 – Long Wall Slat:
Position the Long Wall Slat (V) on the front of the Gym 2-1/2"
from the front Right Corner Post. Fasten the Long Wall Slat
to the Platform End and the End Wall Support with #10 x
1-1/2" Flat Head Wood Screws. The top of the Slat should
be approximately 1" below the top edge of the End Wall Sup-
port.
M
8"
2-1/2".
M
V