Assembly
© Copyright 2014, Creative Playthings, Printed in U.S.A.
60084-101 MonkEY BArS
19865-100 rev C (09-17)
Page 4
aSSEMBLy InSTruCTIOnS
STEP 6 – End Ladder to Top Ladder:
Make sure the screws holding the rungs of the ladder
assemblies face down.
Slide the Top Ladder assembly into place between the rails
of the End Ladder assembly as shown at right. Slip two
Triangle Braces (J) between the rails of the End Ladder and
Top Ladder. Bolt the End Ladder assembly to the Triangle
Braces and Top Ladder using two 1/4 x 3" Hex Bolt
Assemblies.
Lift the assembly at the center. rotate the Triangle
Braces until the holes line up with holes in of the
Top Ladder. Fasten the Triangle Braces to the
Top Ladder using two 1/4 x 1-1/2" Hex Bolt
Assemblies. Fasten the Triangle Braces to
the End Ladder using two 1/4 x 1-1/2" Hex
Bolt Assemblies.
STEP 5 – Monkey Bar Mount:
Place the Monkey Bar Mount (G) against the back of the back
posts on the gym, tight against the bottom of the End Support.
Mark the positions of the holes at the end of the Monkey Bars
Mounts on the posts. Drill 5/16" diameter holes through the
posts at the marks. Align the drill carefully to make sure the
holes go squarely through the posts.
Fasten the Monkey Bar Mount to the posts using two 1/4 x
4-1/2" Hex Bolt Assemblies.
1/4 x 1-1/2"
Hex Bolts
1/4 x 4-1/2"
Hex Bolts
1/4 x 3"
Hex Bolt
G
J
STEP 4 – Gym Slats:
This Monkey Bar Assembly is designed to be an addition
to gym Model number 60082. If the gym assembly is com-
plete, remove the narrow Wall Slats across the back of the
gym. Save two narrow Wall Slats and the fasteners for later
installation.
If the gym is not yet complete, finish assembly without the
narrow Wall Slats. reserve two narrow Wall Slats for future
use.
remove
End Support
