60084-101 MonkEY BArS
19865-100 rev C (09-17)
© Copyright 2014, Creative Playthings, Printed in U.S.A.
Page 5
aSSEMBLy InSTruCTIOnS
STEP 7 — Top Ladder to Gym:
Fasten an Access Bracket to (M) each Top Ladder rail using
1/4 x 1-1/2" Hex Bolt Assemblies.
Lift the Monkey Bar assembly into place as shown. Fasten
each Access Bracket to the Monkey Bar Mount using 1/4 x
1-1/2" Hex Bolt Assemblies
STEP 8 — Walls Slats and Entrance Slat:
From inside the gym, fasten the Entrance Wall Slat (H) to the
back wall support and back platform support, 21" from the
back right post. Use four #8 x 1-5/8" Screws.
Evenly space two narrow Wall Slats between the Entrance
Slat and the back left corner post using four #6 x 1-1/8
Screws each. Typically the gap will be 2-1/8".
STEP 9 – Hand Grips:
Fasten one Hand Grip (L) to the Entrance Slat using two 1/4
x 1" Hex Bolt Assemblies as shown at right.
Use a tape measure to find the height of the Hand Grip above
the back platform support. Mark the height on the back right
corner post. Hold the other Hand Grip against the back right
corner post in the position marked.
Drill 3/16" diameter pilot holes 1" into the post, through the
holes in the handle. Fasten the hand grip using two 1/4 x
1-1/2" Lag Screws and Flat Washers.
1/4 x 1"
Hex Bolts
1/4 x 1-1/2" Hex
Bolt Assemblies
1/4 x 1-1/2" Lag
Screws w/ 3/16"
pilot drill
Parts omitted for clarity
21"
2-1/8" Typical
M
H
Back Platform
Support
