Assembly
ManChester Fun DeCk
19807-100 rev D (07-16)
© Copyright 2011, Creative Playthings
Page 9
Assembly InstructIOns
steP 1 – component removal:
it is required for a number of parts on the
Gym to be removed for assembly. some
of these items will be re-installed later.
all extra parts remaining after assembly
should be saved for possible future re-
pairs. retain all hardware, it may be re-
quired for assembly.
remove the Wall slats across the front
of the Gym. if there is no slide in the front
of the gym, use the Wall slats to fill the
opening after the Fun Deck has been in-
stalled.
remove the hand Grip attached to
the Post where the Fun Deck is to be
mounted.
Attention
, during the initial steps of installation the Manchester gym can sag. to help prevent sagging, do not re-
move the Front Wall support until step 9. Be sure to read this entire document before beginning assembly. if the Gym
Front support does not fit properly in step 9, it may be necessary to raise the front of the gym and push the angled
legs together. Failure to make adjustments early in the assembly can lead to difficulties later in the process.
steP 2 – Drill corner Post:
use a 3/8" diameter drill to make holes through the Corner
Post of the gym where the Fun Deck is to be mounted. hole
placement is shown in the illustration on the right. all holes
should be on the center line of the face of the Corner Post.
Measurements register from the top of the Corner Post.
hand Grip
7-1/4"
6-1/2"
36-1/2"
39-1/2"
40"
Wall slats
