Assembly
ManChester Fun DeCk
19807-100 rev D (07-16)
© Copyright 2011, Creative Playthings
Page 13
Assembly InstructIOns
steP 12 – end ladder to top ladder:
attach one triangle Brace (aa) to the outside of the top Lad-
der rail at point #1 using one 5/16" x 1-1/2" hex Bolt as-
sembly.
align the triangle Brace, top Ladder and end Ladder
rails at point #2 and attach using one 5/16" x 4-1/2"
hex Bolt assembly.
attach the triangle Brace to the end Ladder at
point #3 using one 5/16" x 3-1/2" hex Bolt as-
sembly.
repeat with the opposite top and end Ladder
rails.
steP 13 – top ladder to Gym:
attach one L-Brace (Z) to the outside of the top Ladder
rail at point #1 using one 5/16" x 1-1/2" hex Bolt
assembly.
align the L Brace, top Ladder rail, and Lad-
der Mount at point #2 and attach using one
5/16" x 4-1/2" hex Bolt assembly. the
Weld nut was inserted earlier.
attach the L Brace to the Ladder Mount
at point #3 using one 5/16" x 3-1/2" hex
Bolt assembly. the Weld nut was insert-
ed earlier.
repeat this procedure with the other top
Ladder rail and the Ladder Mount. Level
the top Ladder and tighten all hardware.
steP 14 – Platform end Assembly:
Place the Platform end (P), the end stringer (L), and the two
Corner Posts (a) on the ground next to the end Ladder.
Fasten the Platform end to the Corner Posts using one 5/16
x 4" hex Bolt assembly each through the top hole on the Plat-
form end and second to bottom hole on the Corner Post.
With the counter-bored holes facing up, fasten the end
stringer using two 5/16 x 5-1/2" hex Bolt assemblies through
the Platform end and Corner Posts.
Z
aa
P
a
L
1
2
3
note: align the top Ladder so
the screws securing the rungs
face down.
the Gym end stringer has
been omitted for clarity
1
2
3
