Assembly
LEXINGTON
19686-300 Rev N (01-19)
© Copyright 2005, Creative Playthings
Page 11
ASSEMBLY INSTRUCTIONS
STEP 4 - Platform Ends:
Fasten the Platform Ends (V) to the Corner Posts (F) using
one 5/16 x 4" Hex Bolt Assembly in the Top Hole (only) on
the ends of each Platform End (V).
STEP 5 - Outside Stringers:
Locate the two Outside Stringers (H). The
Outside Stringers (H) are installed to the inside
of the front and rear Corner Posts (F). Attach
each Outside Stringer (H) using two 5/16 x
5-1/2" Hex Bolt Assemblies as shown. The Hex
Bolt should start from the outside of the Gym.
Push each bolt through the bottom hole in the
front or rear Platform Ends and the Corner Posts
before passing through the Outside Stringer.
Make sure the Platform Ends (V) and Outside
Stringers (H) are aligned across their bottom
edges. (The holes in the Outside Stringers
are offset from the center of the board; you
may have to flip the board to achieve proper
alignment.)
Note: The right Platform Side has been omitted
from the illustration for clarity.
V
Left
Right
Front
(Slide)
Back
O
O
V
O
V
H
V
