Assembly
© Copyright 2005, Creative Playthings
LEXINGTON
19686-300 Rev N (01-19)
Page 16
ASSEMBLY INSTRUCTIONS
STEP 18 - Front Wall Slats:
Fasten three Wall Slats (U) to the front Platform End (V) and
the front End Wall Support (AC), as shown. Use four #8 x
1-5/8" Flat Head Wood Screws in each Wall Slat (U). There
should be approximately 2-3/4" between each Wall Slat (U).
The bottom of all Wall Slats should be spaced approximately
1/2" above the platform surface.
Note: When placing Wall Slats, leave no gap larger than
3-1/2" except at entrance or exit points. The Right Wall Sup-
port has been omitted from the illustration for clarity.
STEP 19 - Rear Wall Slats:
Fasten six Wall Slats (U) to the rear Platform End (V) and the
rear End Wall Support (AC), as shown. Use four #8 x 1-5/8"
Flat Head Wood Screws in each Wall Slat (U). There should
be approximately 2-5/8" between each Wall Slat (U).
Note: When placing Wall Slats, leave no gap larger than
3-1/2" except at entrance or exit points. The Right Wall Sup-
port has been omitted from the illustration for clarity.
STEP 20 - Left Wall Slats:
Fasten nine Wall Slats (U) to the left Platform Side (O) and
the rear left Side Wall Support (P), as shown. Use four #8 x
1-5/8" Flat Head Wood Screws in each Wall Slat (U). There
should be approximately 3" between each Wall Slat (U).
Note: When placing Wall Slats, leave no gap larger than
3-1/2" except at entrance or exit points. The right Wall Sup-
port has been omitted from the illustration for clarity.
U
AC
V
U
O
P
This Wall Slat Layout is based on no accessories being
mounted that require an opening for access. Placement of
Wall Slats can vary depending on accessories.
