LEXINGTON WITH TENT ROOF
19685-100 Rev S (07-21)
© Copyright 2005, Creative Playthings
Assembly
Page 15
ASSEMBLY INSTRUCTIONS
Now the basic tower is assembled, it's time to decide where the accessory play features will mount. Consult the
package guide for your specific layout. Install the accessory play features before installing wall slats.
This document continues with the access ladder and slide installation required for almost all packages. Be sure to
adapt the placement for your play package.
5/16 x 1-1/2"
Hex Bolts
STEP 18 — Access Ladder:
Loosely fasten two Access Brackets to the Access Ladder (BB)
using one 5/16" x 1-1/2" hex bolt assembly each, as shown.
Rest the ladder against the platform side. Make sure the bottom
is securely on the ground. The left edge of the access ladder
should be 11" from the end of the platform side.
Check behind the platform support where the brackets rest for
interference before drilling. The brackets can be mounted to the
inside of the ladder rails if needed. Mark and drill 3/8" diameter
holes through the platform side. Fasten each bracket to the
platform side using one 5/16 x 1-1/2" hex bolt assembly.
Note: The access ladder can be mounted on any side of the
gym, provided the placement does not interfere with other
accessories. The access ladder must be mounted well clear of
any swing accessories. Provide space to mount entrance slats
and hand grips on either side of the access ladder.
BB
illustration shows a
different tower
D
A
STEP 19 — Swing Mount:
The Swing Mount (D) can be attached to any side of a gym. One
swing mount is used for a 7 Ft swing beam. No swing mounts are
needed for a 9 Ft Swing Beam.
See the instructions that come with your swing frame for the
steps required to install swing mounts.
STEP 20 — Safety Rail:
If you are mounting a swing beam to this gym, install the Safety
Rail (A) to keep children from walking into the swing area. With
no swings, the safety rail is not needed.
Fasten the safety rail to the corner posts on the same side of the
tower as the swings using two 5/16 x 3" lag screws with 5/16" flat
washers as shown. Use the pre-drilled holes provided.
5/16 x 4"
Hex Bolts
5/16 x 3"
Lag Screws
