© Copyright 2005, Creative Playthings
LEXINGTON WITH TENT ROOF
19685-100 Rev S (07-21)
Page 10
ASSEMBLY INSTRUCTIONS
AA
STEP 3 — First Tower Side:
Raise one tower assembly on edge.
Secure one end of a Sandbox Side (Q) to the corner
post using two 4" hex bolt assemblies. (Align the
blind holes nearest to the bottom of the posts).
Raise one side of the other assembly about 6-1/2
feet from the first and secure the next end of the
sandbox side to it in the same way.
Move to the middle of the posts and secure one Plat-
form Side (O) using four 4" hex bolt assemblies, two
at each end. Make sure the holes along the edge of
the board align closer to the bottom of the posts.
Fron
t
Fro
nt
Back
Back
STEP 4 — Raise Tower, Install Ends:
Lift the top of the tower and settle the tower onto its base.
Mount the remaining Platform Side (O) using four 4" hex bolt as-
semblies, two at each end.
Finish the tower base by installing the second Sandbox Side (Q)
Using four 5/16 x 4" hex bolt assemblies.
O
Q
Q
O
5/16 x 4" Hex
Bolts
5/16 x 4"
Hex Bolts
STEP 5 — Short Tent Pipes:
Slide one 80-3/4" Tent Pipe (AA) into the large hole in the front of the left
rear corner post. Slide the other end into the hole in the back of the left
front corner post.
You may need to loosen or remove one of the bolts holding the platform
side. Repeat with the other 80-34" Tent Pipe and the right corner posts. Re-
store and tighten the bolts holding the platform sides.
