© Copyright 2005, Creative Playthings
LEXINGTON WITH TENT ROOF
19685-100 Rev S (07-21)
Page 12
ASSEMBLY INSTRUCTIONS
I
O
O
STEP 9 — Angle Braces (continued):
Double check the posts are still plumb.
Tighten all connections except the angle braces. Do not over
tighten.
Position all Angle Braces (B) with the angled ends flat against
the corner posts nearest to them. With a pencil, mark the posi-
tion where the holes in the braces rest against the corner posts.
At each mark drill a 3/16" diameter pilot hole 2" deep into the
posts. Fasten the angle braces to the adjacent posts using one
5/16 x 3" lag screw and flat washer each.
Note: The stringers have been omitted from the illustration for
clarity.
STEP 10 — Narrow Platform Boards:
Place the two Narrow Platform Boards (I) tight against the
platform sides on top of the stringers. Fasten the narrow platform
boards to the stringers with eight #10 x 2" screws on each board.
STEP 11 — Platform Boards:
Lay out all nine Platform Boards (N) on the inside and outside
stringers. Check each board to make sure the best looking
surface faces up. Space the platform boards evenly between the
narrow platform boards. Fasten each platform board using eight
#10 x 2" screws.
5/16 x 3" Lag
Screws
#10 x 2"
Screws
#10 x 2"
Screws
N
