© Copyright 2005, Creative Playthings
LEXINGTON WITH TENT ROOF
19685-100 Rev S (07-21)
Page 14
ASSEMBLY INSTRUCTIONS
STEP 16 — Tent:
Drape the Tent (AC) over the three cen-
ter tent pipes with the hem facing down.
Slide one 85" Tent Pipe (AB) through the
pocket at each end of the tent.
Insert the ends of the tent pipes (AB)
into the holes in the end tent supports,
as shown. Loosen the bolts securing the
front end tent support to fit the tent pipes
into place. Re-tighten the hardware when
the tent pipes are seated.
STEP 15 — Center Tent Pipe:
Fit one of the 85" Tent Pipes (AB) into the holes at the top of the
tent posts installed in the previous step.
Hold the tent pipe in place inside one of the tent posts. Use a 1/8"
diameter high speed steel drill to bore a pilot hole through one
side of the tent post and one wall of the steel tent pipe. Secure
the tent pipe to the tent post using one #10 x 1-5/8" screw.
Make sure the two tent posts are plumb and perpendicular to
the gym before securing the other end of the tent pipe to the
other tent post with the pilot drill and screw, as above.
STEP 17 — Secure Tent Pipes:
Use a 1/8" diameter high speed steel drill to bore a pilot hole
through the bottom of a end tent support and one wall of the
steel tent pipe, as shown. Secure the tent pipe to the end tent
support using one #10 x 2-1/2" screw. Repeat with the other
three ends of the tent pipes.
AB
Y
Y
AB
X
X
AC
#10 x 2-1/2"
Screws
