DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
© Copyright 2017, Creative Playthings, printed in U.S.A.
page 7
Assembly instructions
spiral slide Assembly
step 1 — slide entrance Assembly
it is important that the coated lag screws provided in
the Adapter box be used instead of the lag screws
provided in the spiral slide box.
Locate one Mounting Plate (A), one Left Entrance (B) and
Right Entrance (C). Assemble the Left Entrance Section to
the Right Entrance Section using fourteen 5/16 x 3/4" Hex
Bolts, twenty-eight 5/16" Flat Washers and fourteen 5/16"
Lock Nuts.
Attach the Entrance assembly to the Mounting Plate at the
four corners using four 5/16 x 1" Hex Bolts, eight 5/16" Flat
Washers and four 5/16" Lock Nuts as shown in the illustration
on the right. Make sure that the Lock Nuts are installed to the
outside away from the Gym.
NOTE: The Mounting Plate is stamped “TOP". Make sure
that it is positioned properly and that all of the holes around
the Mounting Plate line up before tightening.
step 2 — install slide entrance Assembly
Note: This step requires two people.
Using the hardware (four 5/16 x 5" Hex Bolt Assemblies) from
earlier attach the Slide Entrance Assembly to the Adapter
through the four holes at the corners of the Mounting Plate.
Drill 3/16" diameter holes before inserting lag screws
to prevent the wood from splitting.
Attach the Slide Entrance Assembly through the top and
bottom two holes using four 5/16 x 1-1/2" lag screws and
four 5/16" Flat Washers.
Attach the side center three holes on both sides using six
5/16 x 2-1/2" lag screws and six 5/16" Flat Washers.
step 3 — elbow section Assembly
Locate all of the Elbow Sections.
NOTE: The difference between the top and bottom sections
is the male and female flanges.
Assemble each of the Top Elbow and Bottom Elbow using
thirteen 5/16 x 3/4" Hex Bolts, twenty-six 5/16" Flat Washers
and thirteen 5/16" Lock Nuts as shown in the illustration.
Repeat this process to the remaining Elbow Section and
Outlet Section
A
C
D
B
E
5" Hex Bolt
3/4" Hex Bolts
2-1/2" Lag
Screws
1-1/2" Lag Screws
1-1/2" Lag Screws
3/4" Hex Bolt
(4-1/2" Hex Bolts are
included if needed)
Use Lag Screws
from the adapter
pack
