Assembly instructions
© Copyright 2017, Creative Playthings, printed in U.S.A.
DiRECT ADAPTER FOR SPiRAL & SWOOSH SLiDES
19946-100 Rev B (07-17)
page 8
Entrance
Section
1st Elbow
Section
2nd Elbow
Section
Outlet Exit
Assembly
Run-off Section
step 4 — 1st elbow section
Position the first Elbow Section
directly under the Entrance Section
and rotate two holes off center
clockwise.
NOTE: There are male and female
flanges on all of the sections. Make
sure they match properly.
Attach the two sections together
using twelve 5/16 x 3/4" Hex Bolts,
twenty-four 5/16" Flat Washers and
twelve 5/16" Lock Nuts as shown in
the illustration.
step 5 — 2nd elbow section
Repeat the procedure on Step #4
but rotate the second Elbow Section
counter clockwise two bolt holes.
Attach using twelve 5/16 x 3/4" Hex
Bolts, twenty-four 5/16" Flat Washers
and twelve 5/16" Lock Nuts.
step 6 — outlet exit
Repeat the procedure on Step #5 but
rotate the Outlet Exit Section counter
clockwise two bolt holes.
Attach using twelve 5/16 x 3/4" Hex
Bolts, twenty-four 5/16" Flat Washers
and twelve 5/16" Lock Nuts.
step 7 — run-off section
install the Run-off Section to the
Outlet Exit Section using six 5/16
x 3/4" Hex Bolts, twelve 5/16" Flat
Washers and six 5/16" Lock Nuts.
NOTE: Position the Run-off Section so
that it is flat with the ground surface.
