Ice Cream Stand Instructions - 19930-100L (08/20)
Copyright 2016, Creative Playthings - Printed in U.S.A.
Page 4
Page 4
STEP FOUR - Posts to Supports
Fasten the Post Assemblies to the outside of the Seat and
Table Supports using 5/16 x 2" Hex Bolt Assemblies as
shown at right.
STEP FIVE - Rafters
Fasten the Rafters to the Post Assemblies using 5/16
x 2" Hex Bolt assemblies.
Make sure the Posts are plumb. Rest the angled end
of each Rafter (C) against the adjacent gym post. The
peak of the each rafter should rest approximately 15"
above the top of the platform support (76" above the
ground). Align the inside face of the Rafter with the
inside face of the gym post.
Drill a 1/4" diameter pilot hole 2" deep into each adja-
cent gym post before fastening the Rafters using one
5/16 x 4-1/2" and one Flat Washer each.
STEP SIX - Roof Panels & Center Rafter
Place the 4 Board Panel Assembly (N) on the Rafters, snug
against the gym posts as shown. The cleats on the bottom
of the Panel fit between the Rafters. Secure the Panel to the
Rafters using one #10 x 1-5/8" Screw in each hole.
Hold the Center Rafter (E) under the center of the installed
panel with the holes in the Panel aligned with the center
of the Center Rafter. The angled end of the Center Rafter
should align with the top edge of the Panel in the same man-
ner as the Rafters. Secure the Panel to the Center Rafter
using one #10 x 1-5/8" Screw in each hole.
Place the 2 Board Panel Assembly (M) on the Rafters, with
the top edge snug under the bottom edge of the 4 Board
Panel Assembly. The cleats on the bottom of the Panel fit
between the Rafters. Secure the Panel to the Rafters using
one#10 x 1-5/8" Screw in each hole.
F
G
C
N
M
E
15"
76"
to ground
5/16 x 2"
Hex Bolt
5/16 x 4-1/2"
Lag Screw
#10 x 1-5/8"
Screw
5/16 x 2"
Hex Bolt
1/4" diameter
holes 2" deep
