Ice Cream Stand Instructions - 19930-100L (08/20)
Copyright 2016, Creative Playthings - Printed in U.S.A.
Page 5
Page 5
STEP SEVEN - Table Wall Support
STEP EIGHT - Short Wall Slats
Secure the Table Wall Support (L) between the two Table
Supports using four #10 x 3" Screws. Send the Screws
through the Holes in the Table Supports and into the holes
in the ends of the Table Wall Support.
Place one Short Wall Slat (J) against the Table Wall Sup-
port and gym Sandbox Side, with the top edge approximately
1" below the top edge of the Table Wall Support. The Slat
should be tight against the right hand Table and Seat Sup-
ports. Fasten the Slat using one #10 x 1-5/8" Screw in each
hole.
Secure another Slat in the same way tight against the left
hand Table and Seat Supports.
Evenly space the six remaining Slats and fasten in the same
way. The gaps will be approximately 3/4".
STEP NINE - Table Boards & Cleat
Fasten the three Table Boards (A) to the Table Supports us-
ing one #10 x 1-5/8" Screw in each hole.
Fasten one Table Cleat (D) to the bottom center of the two
front Table Boards using one #10 x 1-5/8" Screw in each
hole. Be sure not to drive the Screws too deep. The tips of the
Screws must not poke through the top of the Table Boards.
L
J
D
A
Gap 3/4"
(Typical)
1"
#10 x 1-5/8"
Screw
#10 x 1-5/8"
Screw
#10 x 3"
Screw
