Ice Cream Stand Instructions - 19930-100L (08/20)
Copyright 2016, Creative Playthings - Printed in U.S.A.
Page 6
Page 6
STEP TEN - Seat
STEP ELEVEN - Chalkboard
STEP TWELVE - Hole Caps
Rest the Seat Boards (H) on the Seat Supports as shown at
right. Align the holes in the Seat Boards with the center of the
Seat Supports.
Fasten the Seat Boards to the Seat Supports using #10 x
2-1/2" Screws in each hole.
Fasten the remaining Table Cleat (D) to the bottom center of
the Seat Boards using one #10 x 1-5/8" Screw in each hole.
Fasten each Seat Block (Q) to the bottom of the Seat Boards
next to a Seat Support using one #10 x 2-1/2" Screw in
each hole. Make sure the tips of the screws do not protrude
through the top of the seat.
NOTE: one angle brace may be removed from the gym to fit the Chalkboard in the position shown.
Hold the Chalkboard (P) against the Post and adjacent gym post at either end of the table. Set the bottom edge approxi-
mately 1" above the table top. Mark the position of the large holes in the Chalkboard on the posts. Drill 1/8" diameter pilot
holes 1" deep at the marks.
Secure the Chalkboard an Chalkboard Battens (O) as shown using four 1/4 x 2" Lag Screws with four 1/4" Flat Washers in
the large holes. Add four #10 x 1-5/8" screws through the smaller holes.
Use two 3/4" Pan Head Screws to secure the Chalkboard to the Battens from behind, though the holes provided.
Perform a final check to make sure all fasteners have been
tightened.
Locate the 1" Hole Caps in the hardware bag. Install Hole
Caps into all the counter-bored holes to cover the hardware.
D
H
Q
Q
P
O
#10 x 2-1/2"
Screw
#10 x 2-1/2"
Screw
#10 x 1-5/8"
Screw
#10 x 1-5/8"
Screw
3/4" Pan
Head Screw
1/4 x 2"
Lag Screw
1/8" diameter
pilot holes
1"
