Creative Conners Stagehand Pro 3, Reference Manual

Page: 13 / 63

Stagehand Pro 3 Reference Manual, 11-20
Page 7 of 56
POWERING UP
After the Stagehand is installed, it is time to power it up and get your machine spinning. The
Stagehand Pro 3 requires a 30-amp, 200VAC-240VAC, 3-phase, 4-wire circuit (3 hot legs and a
ground). The Stagehand Pro 3 is equipped with a circuit breaker on the front panel. Flip the breaker
OFF before applying power.
Input Power
The power inlet on the Stagehand is a 6-pin rectangular plug ( IRC-77mm X 27mm (16B) 6P 35A 400V
Male ). There are many manufacturers of these connectors, our favorite is by ILME: CPM-06. No
matter the manufacturer, the pin-out is shown below:
Figure 12
Included with your Stagehand is a 10’ power cord that has a rectangular power connector on one end
and a more common NEMA L15-30 twist-lock plug on the other end. This adapter cable can make it
easier to power the Stagehand from distros or wall receptacles. The pin-out for the NEMA L15-30
twist-lock plug is shown below: