32
NTP Server
Click (
) keyboard icon in NTP Server frame and the virtual keyboard will appear. Input IP address of NTP server.
NOTE
“Use NTP” function connected to the Time zone, user should set the Time zone correctly to operate the NTP function properly.
NOTE
Currently used NTP is administered by pool.ntp.org and its IP address is 65.23.154.62. However, users are allowed to use IP address of any
NTP site.
Interval
Set clock-update-interval from NTP Server. Normally, user can adjust 1 hour up to 24 hours.
System Clock
Display DVR clock.
Server Clock
Display NTP Server’s clock if Internet is connected to Server Clock. If not displaying, please click (
) Connect button.
When Server Clock is displayed, please click (
) Sync button to synchronize NTP Server’s clock with DVR clock.
Choose ‘OK’ to confirm the clock synchronization.
When users click the storage tab, following screen will appear.
Set S.M.A.R.T. (Self-Monitoring Analysis and Reporting Technology) function for HDD format and auto-display of HDD
information. DVD-RW is not shown here.
Clicking Up and Down button for checking up the status of HDD and DVD-RW devices.
Using E-SATA port will allow users to connect up to maximum 8 HDD +1 DVD-RW. (
B, C and F Type
)
When user installs full storage device and DVD-RW including two e-SATA storage, then following procedures will be listed
as below:
-
1. Internal SATA 1~4 Ports
-
2. External SATA 1
-
3. DVD-RW
Format
User must format when:
-
install new HDD
-
add another HDD
-
replace HDD
-
move HDD (change installation port)
-
remove HDD
Click (
) Add/Remove frame in Format column and choose ‘OK’ on the dialogue box to start formatting.
Following format, DVR will auto-reboot. If there are more than 2 HDDs, please formats each of HDDs. DVR will auto-reboot
Storage