20
Click the box below to select resolution.
-
User can select the resolution among ‘1920x1080 RB’, ‘1920x1080’, ‘1680x1050 RB’, ‘1680x1050’, ‘1280x1024’, and
‘1024x768’
-
The default setting of DVR is ‘1280 x 1024’.
Click the box below to select signal format.
-
User can select the signal output among ‘NTSC’, ‘PAL’ and ‘AUTO’.
-
The default setting of DVR is ‘AUTO’
CAUTION
HDMI CONNECTION MAY NOT BE COMPATIBLE WITH CERTAIN OUTPUT DEVICE.
VIDEO NOISE MAY OCCUR DEPENDING ON THE TYPE OF HDMI CABLE USED. MAKE SURE TO USE AN HDMI-CERTIFIED CABLE
.
CAUTION
BLACK SCREEN WILL APPEAR IF THE MONITOR DOEST NOT SUPPORT THE SELECTED RESOLUTION. UNLESS USER PRESS ‘OK’
DURING BLACK SCREEN, SYSTEM WILL AUTOMATICALLY GO BACK TO THE PREVIOUS RESOLUTION IN 15 SECONDS.
2.2.6 Audio Connections
Connect an audio device to ‘
AUDIO IN
’ and a speaker system to ‘
AUDIO OUT
’. Please use a speaker system with volume
adjustable.
2.2.7 TCP/IP(Ethernet) Connections
Connect to ‘
ETHERNET
’ connector with the LAN cable.
When connect to Internet, use an ordinary LAN cable (Non-cross cable). However, when connect directly to a PC, please
use only ‘Crossover cable’.
2.2.8 Alarm
Connections(TTL)
Connect Alarm Input (Sensor) to ‘AI 1~AI 4 (or AI 16)’ connectors and connect Sensor Common to ‘G’ connector.
Connect Alarm Output (buzzer, siren, etc.) to ‘AO 1~AO 4 (or AO 16)’ connectors and connect Common to ‘G’ connector.
2.2.9
Alarm Connections(Relay (Dry Contact))
Connect Alarm Output (buzzer, siren, etc.) to ‘
NO or NC 1~ NO or NC 2
’ connectors, Power to ‘
COM
’ connector and Ground
to
‘GND’
connector.
2.2.10 RS-485/422
Connections
PTZ Camera connector.
Please use TX+, TX-, RX+ and RX- terminals.