Craftsman CM4.33, Manual

Page: 19 / 48

Title part xxx
Subtitle part xxx
19
craftsman marine diesel engines CM4.33 / cm4.42
Monitoring lights oil pressure and battery
charging current
Make sure that the monitoring lights for oil pressure and
charging current are extinguished and that cooling wa-
ter is coming out of the exhaust line. If not so, stop the
engine IMMEDIATELY.
Never turn the electric main switch to
the ‘off’ position when the engine is run-
ning.
Also: do not turn the starter switch to
the ‘start’ position when the engine is
running. This may cause serious damage
to the starter motor.
Electric engine stop
Before stopping the engine, shift the throttle lever back
to its neutral position, place the gearbox lever into the
neutral position and let the engine idle during a few mo-
ments. Turn the starter switch to the far left position of
‘stop’. After a long trip it is recommended to have the
engine idling for a few minutes, before putting it to full
stop.
When the engine has stopped, turn the key one step to
the right, to the ‘off’ position.
Close the seacock of the raw water inlet and turn the
main electrical switch to the off position, if the engine
will not be used during a prolonged period of time.
Manual stop
Should the engine not respond to the stop command by
means of the starter key, keep the black button on top
of the fuel lift pump depressed during a few seconds.
The engine will stop immediately, by lack of fuel supply.
To start / stop
Engine operation 10