OPERATION
20
OPERATING TIPS
1.
Most efficient snowthrowing is accomplished when snow
is removed immediately after it falls.
2.
For complete snow removal, slightly overlap each swath
previously taken.
3.
Snow should be discharged downwind whenever pos-
sible.
below
surfaces, the skids may be adjusted upward to insure
cleaning efficiency.
5.
On gravel or crushed rock surfaces, the skids should be
Adjust Skid Height”, in the ADJUSTMENT/REPAIR sec-
tion in this manual). Rocks and gravel must not be
picked up and thrown by the machine.
6.
After the snowthrowing job has been completed, allow the
engine to idle for a few minutes, to melt snow and ice ac-
cumulated on the engine.
7.
Clean the snowthrower thoroughly after each use.
8.
Remove ice and snow accumulation and all debris from
the entire snowthrower, and flush with water (if possible)
to remove all salt or other chemicals. Wipe snowthrower
dry.
9.
Before starting snowthrower, always inspect augers and
impeller for ice accumulation and/or debris, which could
result in snowthrower damage.
10. Check oil level before every start. Make sure the oil is at
the FULL mark on the oil fill cap/dipstick.
(see “To
Not
for
Reproduction
