28
29
TURNING LASER TRAC
®
ON (FIG. X)
1. To turn laser on, press on/off rocker
switch (1) to “ON” position.
2. To turn laser off, press on/off rocker
switch to “OFF” position.
ALIGNING THE LASER TRAC
®
The laser line must always be correctly
aligned with the blade to ensure
straight, even cutting. Your tool is
equipped with the Laser Trac
®
cutting
guide using Class IIIa laser line. The
laser line will enable you to preview
the saw blade path on the stock to
be cut before starting the miter saw.
This Laser Trac
®
is powered by the
transformed alternating current supply
directly through the power lead.
The
saw must be connected to the power
source and the laser on/off switch
must be turned on for the laser line
to show.
●
To prevent serious injury, insert a
padlock (not provided) or chain with
padlock through the hole in the
ON/OFF Trigger Switch prior to
making any laser adjustment.
●
Do not remove the lock from the
ON/OFF Trigger Switch during any
laser adjustment.
Fig. X
1
WARNING
!
AVOID DIRECT EYE CONTACT (FIG. Y)
● Laser radiated when
Laser Trac
®
is turned on. Avoid direct eye
contact.
● Laser Warning Label:
Max. Output < 5 mW Wavelength:
630-660nm, Complies with 21 CFR
1040.10 and 1040.11. Class IIIa
Laser Product. (FIG. Y)
●
Laser Aperture Label: AVOID
EXPOSURE: Laser radiation is
emitted from this aperture. (Fig. Y)
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.
● CAUTION: Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
● CAUTION: The use of optical
instruments with this product will
increase eye hazard.
WARNING
!
