22
23
REMOVING AND INSTALLING THE
TABLE INSERT (FIG. L, M, N)
To avoid injury:
● Always unplug the saw to avoid
accidental starting. Remove all
small pieces of material from the
table cavity before performing
any cuts. The table insert may
be removed for this purpose, but
always reattach the table insert
prior to performing a cutting
operation.
● Do not start the compact slide
miter saw without checking for
interference between the blade
and table insert. Damage could
result to the blade, table insert or
turntable if blade strike occurs
during the cutting operation.
1. Remove the fence (1) by removing
the four hex screws (2) with a 6 mm
hex key. (Fig. L)
2. Loosen and remove the four
screws (3) on the table insert (4)
with a Phillips screwdriver and
remove the table insert. (Fig. M)
WARNING
!
3. To install, reposition the table insert,
install the four screws and tighten.
4. Check for blade clearance by
moving the slide carriage through
the full motion of the blade in the
table slot.
5.
Replace the fence and fix the fence
by tightening the four hex screws (2).
NOTE:
●
If the dust needs to be cleaned
under the table insert, press the
clip (5) at the front end of the table
insert to open it. (Fig. N)
●
After the dust is cleaned up, push
and press the table insert (4) back
to the original position.
Fig. L
1
2
2
Fig. M
3
4
Fig. N
5
4
