page 7
Remove existing wall switch.
Wire the wall control as follows, using wire
connectors provided to secure each
connection:
Connect BLACK wire with WHITE STRIPE (AC
IN L) from wall control to BLACK (AC IN L) wire
in the outlet box.
Connect SOLID BLACK (TO MOTOR L) wire
from wall control to BLACK wire from fan in
the outlet box.
Connect BLUE (FOR LIGHT) wire from wall
control to BLUE wire from light in the outlet
box.
Connect GREEN wire with YELLOW STRIPE
(GROUND) from wall control to
GREEN/GROUND wire in the outlet box.
*Wrap each wire connector separately with
electrical tape as an extra safety measure.
Gently push wires and taped wire connectors
into outlet box.
Attach wall control to outlet box and secure
with screws from original wall switch. Attach
plate (included) to wall control using 2 screws
provided with the wall control.
(wiring for wall control)
solid black
(TO MOTOR L)
blue (FOR LIGHT)
black
(AC IN L from
breaker box)
black with
white stripe
(AC IN L)
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall control
plate
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio
or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
blue
ound
ound
black
green with yellow
stripe (GROUND)
6. Wiring.
7. Canopy Assembly.
canopy
hanging bracket
screw
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen
the other screw. Lift canopy to hanging
bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging
bracket and push up. Twist canopy to lock.
Re-insert screw that was previously removed
and then tighten both screws securely.
