page 8
8. Blade Assembly.
WARNING: To reduce the risk of serious bodily
injury, DO NOT use power tools to assemble the
blades. If screws are overtightened, blades may
crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws/washers in
hardware pack. Hold blade arm up to blade
(sold separately) and align holes. Insert 3 blade
attachment screws/washers with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws/lock washers from
underside of motor. If plastic motor locks are
installed with blade arm screws/washers, discard
plastic motor locks (save blade arm screws/lock
washers to secure blade arms). Align blade arm holes
with motor screw holes and attach blade arm with
blade arm screws/lock washers. Before securing
screws permanently, repeat procedure with
remaining blade arms. Securely tighten all screws.
NOTE: Tighten blade arm screws twice a year.
blade attachment
screws/washers
blade arm screws/
lock washers
motor
housing
plastic
motor
lock
blade arm
blade
blade attachment
screws/washers
9. Light Kit Assembly.
Remove 1 screw from motor plate on underside
of motor housing and partially loosen the other
2 screws. Align slotted holes in center of fitter plate
with loosened screws in motor plate, allowing
molex connections from motor housing to come
through hole in middle of fitter plate. Twist fitter
plate to lock. Re-insert screw that was removed
and secure all screws.
Connect WHITE wire from motor housing to
WHITE wire from LED light kit. Connect BLACK
(or BLUE) wire from motor housing to BLACK wire
from light kit fitter. Be sure that molex connections
snap together completely.
Remove 1 screw on underside of fitter plate and
partially loosen the other 2 screws. Carefully
arrange wiring within fitter plate. Align slotted
holes in LED light kit with loosened screws in
fitter plate. Re-insert screw that was previously
removed and securely tighten all 3 screws with
a Phillips screwdriver.
Align grooves on shade with nodules on inside of
fitter plate. Turn shade to the RIGHT (clockwise)
until it no longer turns.
NOTE: Pull down VERY GENTLY on shade to make
sure that shade is secured completely.
fitter plate
motor
plate
motor
housing
LED light kit
shade
molex
connections
groove
nodule
