page 7
6. Wiring.
WARNING
: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National Electrical
Code. If you are unfamiliar with electrical wiring or if
the house/building wires are different colors than
those referred to below, please use a qualified
electrician.
Note
:
Excess lead wire length from the fan can be cut
to the desired length and then stripped.
WARNING
: If using this fan in a
WET
location, this
fan must be connected to a supply circuit that is
protected by a Ground Fault Circuit Interrupter
(GFCI) to reduce the risk of personal injury, electrical
shock or death.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect the
BLACK
wire and the
BLUE
wire from fan to
BLACK
wire from ceiling with wire
connector provided.
Connect
WHITE
wire from fan to
WHITE
wire from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires together from fan to
BARE
/
GREEN
wire from ceiling
with wire connector provided.
If you intend to control the fan light with a separate light switch, connect
BLUE
wire from
fan to the
BLACK
(or
RED
) supply from the independent switch.
* Wrap each wire connector separately with electrical tape as an extra safety measure.
This fan is remote control adaptable (remote control sold separately).
white supply wire
*
black
black
white
white
blue
black supply wire
from
ceiling
from fan
ground (green
or bare)
ground
(green or bare)
7. Canopy Assembly.
Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that
was previously removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with screw heads
in bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
canopy
hanging bracket
screw
canopy cover
screw
