12. Light Kit Assembly, 1-light Options.
shade
bulb
motor
housing
light kit
fitter
(for fan
pull chain)
finial
finial plate
threaded washer
Remove 3 screws from outer edge of switch
housing (at top of light kit fitter).
Connect male plug from motor housing to
female plug from light kit, matching up the
colors on the male plug with the colors on the
female plug for correct fit. Be sure that plugs
connect securely.
Carefully arrange wiring within fitter plate.
Align holes in switch housing (at top of light kit
fitter) with holes in switch housing plate.
Re-insert screws that were previously removed
and securely tighten all 3 screws with a Phillips
screwdriver.
Install bulbs included with light kit.
IMPORTANT
: When you need to replace bulbs,
please allow bulbs and shade to cool down
before touching them.
Remove finial, finial plate and threaded washer
from threaded rod on underside of light kit
fitter. Raise shade in order to guide pull chains
through appropriate holes at bottom of shade.
Align threaded rod on light kit fitter with hole
in middle of shade and push up gently,
allowing threaded rod to come through hole.
(
Be sure pull chain for fan operation does not rub
against bulb during operation
.) Secure shade
with threaded washer.
Do NOT overtighten
threaded washer as shade may crack or break.
Align hole in center of finial plate with threaded
rod, allowing pull chains to come through
appropriate holes in finial plate, and push up.
Thread center pull chain through hole in finial
and re-attach finial.
Do NOT overtighten finial as
shade may crack or break.
Please proceed to Section 13 on the following
page to complete installation.
motor housing
switch housing
plate
light kit fitter
switch housing
*For
Model OS211
, follow instructions on this page.
page 11
switch
housing
