9. Light Kit Assembly. (cont.)
Remove 4 screws from outer edge of fitter
plate.
Carefully arrange wiring within light kit fitter.
Align holes in top of light kit fitter with holes
in outer edge of fitter plate. Re-insert screws
that were just removed and tighten all 4
screws securely with a Phillips screwdriver.
Install 4 candelabra base 4 watt LED bulbs
(included).
IMPORTANT: When replacing bulbs, please
allow bulbs and light kit fitter to cool down
before touching.
page 9
LED bulb
light kit fitter
10. Assembly of Handheld
Remote Control.
IN ORDER TO USE THE HANDHELD REMOTE
CONTROL, PLEASE CONTINUE WITH SECTION 10
for remote control assembly instructions. If you
have already installed the wall control but do not
wish to use the handheld remote control, please
proceed to Section 11.
Gently pull on remote control cover to separate
top and bottom parts. [Refer to diagram 1.]
In order to use wall control as a handheld
remote control, cut each wire on wall control
(that was not previously used)--use wire cutters
to cut off each wire as close to the wall control
as possible. [Refer to diagram 2.]
Install one 12-volt battery (included) in wall
control. [Refer to diagram 2.]
WARNING: Battery is to be inserted with the
correct polarity.
Since this fan comes with dimmable LED
bulbs, the dimmer switch (labeled DIM and
ON) has been pre-set to the "ON" position
(DIM). If you do not wish to have dimming
capability, please move the switch to the
"OFF" position (ON). [Refer to diagram 2.]
["Assembly of Handheld Remote Control"
continued on next page.]
(top)
(bottom)
remote control
cover
diagram 1
screws
diagram 2
dimmer
switch
wall control
wire
wire
wire
12V battery
DIM ON
motor
housing
