page 11
11. Automated Learning Process./Activating Code.
CAUTION
:
The wall and/or handheld remote control can be programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other programmable receiver or fan.
Restore electrical power and then, if using wall control, set slider switch on wall control to the ON
position. Within 60 seconds of turning on the wall control, press and hold the
OFF
button on the wall
control for 5 seconds or until light blinks twice.
Turn power off again for at least 5 seconds
and then turn power back on. Within 60 seconds of restoring
the power, press and hold the
OFF
button on the front of the handheld remote control for 5 seconds or
until light blinks twice.
Test the fan functions to confirm learning process is complete --
See Section 13.
13. Testing Your Fan.
12. Remote Control Operation.
ON/OFF
slider switch - turns
wall control
ON or OFF
(ON/OFF slider switch not
functional on handheld remote)
HIGH
button - turns
fan
to HIGH speed
MED
button - turns
fan
to MEDIUM speed
LOW
button - turns
fan
to LOW speed
OFF
button - turns
fan
OFF
L1
button - turns
light kit
ON/OFF when pressed once;
dims
light kit
when pressed and held down
wall control
handheld
remote control
1
1
-
1
1
-
It is recommended that you test fan before finalizing installation. Restore
power from circuit box and light switch (if applicable). Test wall control
(optional installation) by locating ON/OFF slider switch on wall control, then
set to the ON position. Test light and dimmer function and then test fan
speeds. Next, locate handheld remote control. Test the light ON/OFF
function by pressing the L1 button; test the dimmer function by pressing the
L1 button and holding it down for up to 5 seconds. Test fan speeds with the
different fan speed buttons. If the wall and/or handheld remote control
operates all of the functions of the fan, battery (batteries) has (have) been
installed correctly. If the wall and/or handheld remote control do (does) not
operate all of the fan/light functions, refer to "Troubleshooting" section to
solve any issues before contacting Customer Service.
Turn fan completely off
before
moving the reverse switch (located on top of
motor housing). Set reverse switch to recirculate air depending on the
season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat setting in summer and
lower your thermostat setting in winter without feeling a difference in your
comfort.
Important
: Reverse switch must be set either
completely LEFT
or
completely
RIGHT
for fan to function. If the reverse switch is set in the
middle
position
(
diagram 3
), fan will not operate.
NOTE
: If the wall control/handheld remote control interferes with other
appliances,
turn power off first
and then go back to the instructions in
Section 11.
diagram 1
diagram 2
diagram 3
motor
housing
reverse
switch
